A weak TV signal can make watching television a frustrating experience. It can be caused by a variety of things, from bad installation to obstructions and the type of antenna. Luckily, there are some simple things that you can do to improve your reception and resolve these problems.

Image credit

One of the best tips for improving a weak television signal is to use an indoor antenna to get rid of that pesky coaxial cable. The long cable runs from your antenna to your TV can cause significant signal loss. The solution is to use a high quality, flat cable, which can reduce the distance between your OTA antenna and your TV by as much as 50%.

Another way to improve your OTA signal is to try using a different mounting location for your aerial. This may seem like a simple tip, but it can have a huge impact on your reception. You can use free online tools to find out where your local broadcast towers are and then move your OTA antenna accordingly. This will help to clear the signals it’s trying to receive from obstacles such as trees and buildings. For advice on TV aerial installation Stroud, go to https://steveunettaerials.co.uk/our-services/aerial-services/tv-aerial-repair/tv-aerial-repair-stroud/

The other option is to install your TV aerial higher up. This won’t always be possible, but it can have a dramatic impact on your reception. Typically, this means mounting it on the chimney or gable end wall of your property but it could also mean installing a higher mast on the roof if this is the only option available to you. This will give your aerial a better view of the transmitter and can significantly increase the strength of your broadcast signals.

Image credit

If you’re still struggling to get a good signal after following all of these tips, then you might need to invest in a TV amplifier. These handy little devices boost your OTA signals and can help to improve even the most difficult TV reception issues. If you do decide to go down this route, it’s important that you choose a device with a low noise output as this will keep the interference to a minimum.

You can also try a distribution amplifier if you’re running multiple TVs off of the same antenna. These devices can increase your OTA signal by up to 18dB and are a great alternative to a passive splitter. Just be sure to choose a model that has a continuous adjustment to set the amount of attenuation needed.

Leave a Reply

Your email address will not be published. Required fields are marked *